Miranda Vertigo XG User Manual download pdf (Page 71)

Vertigo XG Configuration Guide 4-37

XG Dashboard - Vertigo XG’s Configuration Software

MANUAL PORT INFORMATION

• STARTING PORT: Specifies the port number to use as the starting point

for searching for devices.

• P

ORTS TO SCAN: Specifies the number of ports to scan starting at the

port number specified in the Starting Port.

IP INFORMATION

Displays a list of IP addresses to scan to detect Vertigo XG/CG devices.

The IP address is that of the machine that the Vertigo XG/CG is running on.

You can get this IP address either by typing IPConfig on the command

prompt, or by using the IP address listed on the Vertigo XG/CG software’s

dialog box.

• A

DD: Enter a specific IP address that you suspect the device to be

using.

• S

ORT: Arranges the IP addresses added to the IP information list in

descending numerical order.

• R

EMOVE: Removes the selected IP address from the IP Information list.

UTOMATIC The device discovery’s automatic mode performs a thorough search for all

of the Vertigo XG and VertigoCG devices on your local machine or on your

network.

• O

NLY SCAN LOCAL MACHINE: Rather than searching for all of the

Vertigo XG and VertigoCG devices on your network, this setting limits

the search to finding all the XG/CG devices connected/on your local

machine.

• T

IME OUT: Sets a time limit at which to stop the search for devices. The

default value is 5 seconds.

EVICE MONITORING REFRESH RATE: Sets the frequency (in seconds) at which to poll the devices

to see if they are active or inactive. The default value is 10 seconds. See

“

Monitoring the status of a device” on page 4-9 for more information.

AVE DEVICE LIST ON

EXIT

The Save Device List on Exit automatically saves the device list when you

exit XG Dashboard. By default this parameter is not enabled. See “Saving

the device list” on page 4-8 for more information.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 115 116

No comments

Miranda Vertigo XG User Manual Page 71