Miranda Vertigo XG User Manual download pdf (Page 105)

Vertigo XG Configuration Guide 5-27

Vertigo XG Configuration Procedures and Schemas

HD 1080i30M Configuration Settings - Fill Only, Input and Output

The table below provides you with a quick reference of the basic Vertigo XG device settings

for a scenario with the following characteristics:

• Resolution format: 1080i30M

(Depending on the region, choose the appropriate frame rate format: 1080i25,

1080i30M, or 1080i30.)

• Input: Fill only

• Output: Fill only

• Number of channels: 1 (single, assigned as A for the input and output channels)

(You can assign the channel as either A or B, but the input and output pair must match.)

NOTE

The schemas presented in this section are generic and demonstrate possible minimal

settings based on the specified profiles. Only the indicated settings are relevant to the

profile, and all other parameters are meant to be set to their factory default state. These

schemas are for demonstration purposes only. Be sure to configure your Vertigo XG device

based on all of your specific rendering needs. See “

Device Settings Tab and Pages” on

page 4-12 for more information about the Vertigo XG device settings.

NOTE

Depending on the installation, you may need to adjust the horizontal and vertical delay

parameters after Genlock is set. These settings are located on the Device Settings’ Genlock

page (see “Genlock Page” on page 4-28).

Dashboard Tab Page Parameter Name Setting Name Set to / State

Device Settings General Device Output Fill Enabled

Device Settings Resolution Rendering Resolution 1080i30M

Input Resolution 1080i30M

Output Resolution 1080i30M

Device Settings Genlock Source Blackburst

Resolution 1080i30M

Device Settings Video Input Channels A

Output Channels A

YUV Processing GPU-PS Enabled

Device Settings Watch Dog Enable Fill Enabled

Enable Key Disabled

Device Settings Video Software Passthrough Enabled

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 115 116

No comments

Miranda Vertigo XG User Manual Page 105