Miranda Kaleido-X16 Installation Manual download pdf (Page 15)

Kaleido-X16

Hardware Description & Installation Manual

PSU slot locations

Two PSUs installed in a frame; front cover removed

Removing a Power Supply

To remove a power supply, do the following:

1. Open the front door of the frame and locate the power supply (PSU) you would like to remove (either

the left or the right side).

2. Pull on the handle on the right side of the PSU and pull the PSU out of the frame.

Installing a Power Supply

To install a power supply, do the following:

1. Position the power supply (PSU) in front of an empty power supply slot in front of the frame, with the

connector end towards the frame and the PSU handle on the right side.

2. Slide the PSU into the empty slot, moving it gently until it contacts the sockets at the rear of the slot.

3. Push firmly but gently on the PSU faceplate until the PSU’s connectors have mated with the frame's

sockets, and the PSU will go in no further.

Slot A Slot BPSU A removed from Slot A

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 81 82

No comments

Miranda Kaleido-X16 Installation Manual Page 15