Miranda Kaleido-X16 Operations Instructions download pdf (Page 27)

Kaleido-X16

Quick Start Guide

7. Change the ABT’s network settings, as necessary, then click Apply & Reboot.

Step 3: Default Layout Selection

If your system was configured prior to shipment, then the designated layout will show up on all displays.

Otherwise, a gray screen will appear with the following message in the middle:

“No layout has been assigned to this room. Please load a layout.”

To select a default layout, do the following:

1. Connect a mouse to the RCP2.

2. If you have not already done so, log on to the Kaleido-X16 from the RCP2. See “Configuring the Kaleido-

RCP2 Unit with Default Settings” on page 10.

3. Right-click anywhere on the monitor wall, point to Monitor Wall (if you clicked a widget), and then

click Load layout on the shortcut menu.

Note: If you purchased more than one Audio Bridge Terminal unit, keep in mind that they all ship

with the same default static IP address. Make sure to assign each of them a different static IP

address before connecting them to the network, if DHCP is not used.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

No comments

Miranda Kaleido-X16 Operations Instructions Page 27