Miranda Kaleido-X16 Operations Instructions download pdf (Page 16)

Setting Up the Kaleido-X16

Configuring the Kaleido-RCP2 Unit with Default Settings

To configure the Kaleido-RCP2 unit with default settings, do the following:

1. Physically connect the Kaleido-RCP2 unit to the network using an Ethernet cable.

By default, the Kaleido-RCP2 is shipped with DHCP enabled, so it will automatically be assigned an

IP address by a DHCP server. If no DHCP server can be found, the Kaleido-RCP2 will default to its static

IP address.

2. On the RCP2 unit, press the ENTER key and hold it until the ESC button lights up.

3. Press ENTER to confirm CONFIGURATION will scan for an available room.

The RCP2 should discover ROOMX16.

4. Press ENTER to confirm.

5. Press ESC to return to Standard mode.

Frame IP address 10.0.3.70

Network mask 255.255.0.0

Gateway 10.0.0.1

Note: If the IP address of the Kaleido-X16 has been changed (i.e. it no longer corresponds to the

as-shipped configuration), it is still possible to determine the IP address. To determine the IP

address of your Kaleido-X16, see “Finding the System IP address, System Name, and Application

Version” on page 11.

IMPORTANT: The Kaleido-RCP2 is powered through its RJ-45 Ethernet connector (a Power-over-Ethernet

connection). However, the Kaleido-X16 does not feed power through its Ethernet connections.

To power the Kaleido-RCP2, you must therefore source power from a separate device with a

compatible PoE Ethernet connection.

Notes

• If you need to operate with a fixed IP address, you must use the Configuration menu to

disable DHCP and set up the correct IP address, Network Mask, and Gateway.

• To access Kaleido-X rooms located in other subnets, the RCP2 must be configured with

the appropriate unicast IP addresses (See the “Configuring Unicast IP Addresses” section

in the “Peripheral Equipment” chapter of the Kaleido-X16 Hardware Description &

Installation Manual.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

No comments

Miranda Kaleido-X16 Operations Instructions Page 16