USER’S GUIDE
16 | Kaleido Remote Control Protocol (Gateway)
programID
timeOfDay
timeZone
o The value field is escaped as defined in the XML protocol for an attribute value.
o For instance, ABC"DEF\GHI<JKL>MNO/PQR&STU;VWX'YZ
becomes ABC"DEF\GHI<JKL>MNO/PQR&STU;VWX'YZ
o The attributes order is not guaranteed and may change for two consecutives calls to the
same command.
<nack/>: there is a syntax error in the XML command.
Note: If the MultiData component is not assigned to a text component, no values will be included
in the information returned to the user from the gateway. Make sure to assign the MultiData
component to a text label component.
setKTimer KX K2 AQ
This command is used to configure the specified countdown timer component.
<setKTimer>set id="TimerID" preset="HH:MM:SS" direction="Direction"
loop="Loop" </setKTimer>
Where:
o TimerID is the ID of the countdown timer component to modify.
o HH:MM:SS is the preset value for the countdown timer component.
o Direction is the direction to count, either UP or DOWN.
o Loop indicates if the counter must count continuously. This value can be either ON or
OFF.
Gateway response:
<ack/>: The command was recognized by the Gateway.
<nack/>: The Gateway was not able to recognize the command.
setKTimer2 KX K2
This command is used to configure a timer in a Kaleido-K2 or Kaleido-X series multi-viewer
system.
<setKTimer2>set TimerName="NAME" StartTime="HH:MM:SS:FF"
PresetTime="HH:MM:SS:FF" TimerMode="Timer mode" EndMode="End mode"
</setKTimer2>
Where:
Comments to this Manuals