Installation Manual
Figure 2.4.5 AES-EBU connector pinout
Figure 2.4.6 Installing the Lexan plate on Alto-TBA-
AG
2.4.8 PC Audio Input
Connect a 3.5 mm audio jack to provide an analog stereo audio input coming from a personal computer. Note
that this audio signal is input at its nominal level, which is controlled by the originating computer. Make sure that
the level is within specifications (see section
4 “Technical Specifications”) by adjusting the level on the
originating computer.
2.4.9 Component Analog (RGBHV) Output
Analog progressive scan component video output (DE-15P connector). Connector pinout is shown in figure
2.4.7 below.
Figure 2.4.7 DE-15P connector pinout
2.4.10 DVI Output
Digital progressive scan component output (DVI digital connector), with resolutions as shown in the chart on
page 7 for the DVI input.
For optimum performance, good DVI cables should be used. For instance, cable model D-766 from Cable4PC
(
www.cable4pc.com) is recommended.
10 | Kaleido-Alto & Kaleido-Quad
Comments to this Manuals