Miranda HMP-1801 Instruction Manual download pdf (Page 11)

GUIDE TO INSTALLATION AND OPERATION

HMP-1801 | 7

2 Installation

2.1 Installation of Rear Connector Panels

Miranda Densité-series cards are each associated with a rear connector panel, which must be installed in the Densité

frame before the card can be inserted.

The HMP-1801 card is sized to fit into Miranda’s Densité-2 frame. One rear connector panel is available to fit the

Densité 2 frame:

• HMP-1801-DRP

With the use of an available adapter, the HMP-1801 can be installed in a Densité-3 frame (see section 2.3 below).

Two different rear connector panels for the HMP-1801 are available for this frame:

• HMP-1801-3SRP

• HMP-1801-2OUT-3SRP

The Densité-2 rear panel can also be used in a Densité-3 frame, with the addition of an available adapter:

• HMP-1801-DRP + DENSITE DRP-3RU

All cards and rear panels can be installed with the frame power on. The card has connectors which plug into a mid-

frame mother board for distribution of power and for connection to the controller card, and a second connector which

plugs directly into the rear connector panel for input and output.

The rear connector panel must be installed with the card out of the frame.

• To remove an existing card from the slot, tilt up the swivel handle on the front of the card to lever the

connectors apart, then use the handle to pull the card straight out of the slot.

Densité-2 frame – rear panel installation Densité-3 frame – rear panel installation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 76 77

No comments

Miranda HMP-1801 Instruction Manual Page 11