Miranda UAP-1783 Operations Instructions download pdf (Page 28)

GUIDE TO INSTALLATION AND OPERATION

24 | UAP-1783

Color samples – the three samples show the currently-selected color for the upper, middle and lower

zones of the meter.

Overload Counter - The overload cursor appears on the meter as an arrowhead in the meter scale. The

two pulldown boxes set the position of the overload cursor on the left and right meters. If the audio level on

that channel goes above the cursor, the Overload Counter at the top of the meter is incremented. The

Reset Counter box is available on the RALM - Connections tab.

Phasemeter – this is a small meter that represents the phase correlation factor. Nominal position is in the

center, which also indicates the absence of signal. The red side, up to the left end of the meter indicates the

level of phase opposition and the green side, up to the right end indicates the level of phase amplitude.

3.3.8 A-BUS

The UAP-1783 can be used stand alone or as a

companion to provide additional audio channels

for other Densité cards. The A-BUS (audio bus)

links the UAP-1783 to the other cards and is used

to configure the system and to display the

presence of other installed cards.

A-BUS Config:

Select whether the A-BUS is to be disabled, and

whether this UAP-1783 is Master, Slave 1 or Slave

2 in the A-BUS configuration.

• Not connected to Audio Bus – when the A-

BUS is disabled, it is not possible to detect

other attached cards in the system.

• Slave 1 of Video Card – used for a two-card

system when the other card is a video

processor.

• Slave 1 of Video Card, Slave 2 is present –

used for a three-card system, with a video

processor and another audio processor

configured as Slave2.

• Slave 2 of Video Card, Slave 1 is present –

used for a three-card system, with a video

processor and another audio processor

configured as Slave1.

• Master – the card is standalone, or used as a master for another audio processor configured as Slave.

This mode is not available when a video card is attached to the A-BUS.

• Slave of Audio Master Card – used for a two-card system when the other card is a audio processor

configured as Master.

Status:

• V Presence – turns green to monitor the presence of a video card in the A-BUS configuration.

• A2 Presence - monitors the presence of another audio card in the A-BUS configuration. The icon is

labeled A2 if this card is Slave1, and is labeled A1 if this card is Slave2.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Comments to this Manuals

No comments

Miranda UAP-1783 Operations Instructions Page 28

Comments to this Manuals

Related products and manuals for Audio cards Miranda UAP-1783